Recent Questions :: Technical
Remote sensing GPS, GIS are
4. All of the above
Asked by: Pornima Jagtap on Aug 29, 2019.EDIT
State the values of minimum eccentricity for no tension at the base of the rectangular and circular beam. What is a condition for no tension at the base?
Asked by: Rajkumar Chaudhary on Aug 25, 2019.EDIT
What is the colour of a black box in aircraft?
Asked by: Nikson D on Aug 20, 2019. Answers (1)
The most important factor, which determines the maximum height to which water can be lifted by a pump at standard temperature is the
A) Barometric pressure
B) Speed and Diameter
Asked by: Salahuddin on Aug 13, 2019.EDIT
Consider that you are representing a client and acts as a consultant to a 25 story office building complex. The structural engineer specified concrete class c-50 and steel grad S-460. However, the quality of concrete produced by the contractor was far below the specified concrete quality. This was noticed after the 2nd-floor slab was cast .what do you understand by c-50 concrete and S-460 steel? What would be your reaction and who shall be responsible? What would you do if you were a contractor's representative? What would you do if you were a consultant's representative?
Asked by: Fre on Aug 8, 2019.EDIT
What is meant by writing communication?
Asked by: Vrushikesh Patil on Aug 3, 2019.EDIT
What are the steps of gram staining?
Asked by: Bertha on Aug 2, 2019.
Difference between inferiority and humbleness.
Asked by: Riya on Jul 31, 2019.
A transdermal product is designed to deliver drugs to the following sites.
A) General circulation
B) Stratum basale
C) Stratum spinosum
D) Stratum granulosum
Asked by: Glorious Tembo on Jul 29, 2019.EDIT
Consider this C Program or Java Program. It reads integers from the standard input (until it gets a negative number) and puts them into an array. After that it calls processArray on the array, and then prints the contents of the array on standard output.
Currently, processArray does not modify the array. You have to change this program so that any number in the array is replaced by -1 if it divisible by 7, with -2 if it is greater than 100, and with -3 if it is divisible by 7 and greater than 100. To do this, you have to put your code inside processArray. Do not change anything else in the program.
Asked by: Geetika on Jul 25, 2019.EDIT